Loose Mineral Foundation Dispensing Brush

Step 1- Prep the Brush
To prep the brush, pump it three times; then make small circular motions on the back of the hand or in a tissue to release the powder. At this point, the brush is ready to use. If the minerals are not releasing from the brush, repeat the prepping stage. This should be a one time process and not be repeated on a daily basis.

Step 2- Application
To begin, start at the top of the forehead using small circular motions. Go thoroughly around one side of the face and up the other side, ending at the forehead. For natural coverage, complete this process two to three times. For complete coverage, repeat process three to five times.

Step 3- Cleaner
To clean the brush head begin by saturating a small area of a paper towel with Brush Cleaner. Holding the brush upright (bristles pointing upward), gently rotate the brush head into the paper towel using circular motions until it appears clean. Note: Cleaning the brush head is for hygiene, not to restore it to its original colour.

Step 4- Troubleshooting
If the brush gets "clogged," hold it upright and tap the brush against the palm of the hand or a hard surface. This releases any powder that has accumulated at the base of the brush head. A “clogged” brush usually occurs from over pumping the brush.